NOTE! The piece marked with RED is to be installed when using the NEW McLeod flywheel. Slide machined piece until it bottoms on slave cylinder.

NOTE! The piece marked with the black mark is to be installed when the McLeod flywheel is surfaced for the first time to compensate for material removed from the flywheel.

For late model LS1s use yellow or tan pieces only****(1999 on up)

CAUTION! If vehicle has more than 35,000 miles, a new hydraulic slave is recomended. Always bleed clutch slave cylinder. Flush with DOT 4 Fluid ***
Nathaniels Auto Performance installs and recomends McLeod clutchs & flywheels.

For any questions regarding installation
contact McLeod clutches at (714)630-3668 or Nathaniels Auto Performance at (713)780-8666

CAUTION! Do NOT use these machined pieces with factory clutch or any other brand clutch.

Note! Do not discard the spring as on some hand written instructions.
Note! Cut one coil off from the spring and reinstall spring back on in its original position!!!
Note! If you are replaceing the slave cylinder with a new one, use only the yellow.